Building an Organ
!!!! CONTACT PAGE !!!! *
S.D MidiPlayers For Sale £109.99 *
Midi Pipe Organs For Sale *
SOLENOIDS - PUSH or PULL ,CHEAP !! *
Pallet Magnets*
Sourcing Pipes & Parts *
ORGAN Building 1 *
ORGAN Building 2 *
Building an Organ *
MY COMPOSITIONS *
SOUNDFILES *
Organs built *
3 / 4 rank Organ *
Bureau pipe organ *
"HI-FI" Organs*
Midi Files*
Pianola Midi Player & roll reader.
Me - My Workshop - & My Organs.
Make Floppies for DISKLAVIER !!
THIS PAGE IS ALWAYS BEING UPDATED
FRONT PIPES (rear & centre pipes on previous page)
WINDCHEST TOP , MARKED AND DRILLED
Measure 5 inches from the pipe feet
measure diameter for the pipefoot holes.
The airfeed Flange ,and hole in the windchest side. (pipe i.d.= 32mm) hole required = 34mm for a tight fit
pillars for the rackboard = 5 inches long.
rackboard marked and drilled, ready for fitting.
Two solenoids , Fit all loosley before using screws
All Chest magnets fitted = 40 ohms - 5/8th inch pallet diameter.
Windchest marked with required "note" and line so it's easier to line up the pallets.
completed
Bare windchest
Lousy drawing , But it shows the diode connections on the solenoid, but you will not need these if using only one rank together with a decoder from J-Omega.
solenoid wired, showing Suppression diode & blocking diode.
Windchest now all wired. Showing the 2 "D" type 25 pin plugs
Plug 1 , also the socket for the + common feed.
Plug 2
Windchest With Pipes Fitted
Windchest With Pipes Fitted
Frame
WANTED !!!! 1000,00 pounds REWARD.
Blower finished, I am painting it black.
Frame with windchest & Keyboard
The power supply & Midi Decoder,ready for wiring.This unit , when completed will be a Drawer ,fitted under the windchest ,at the rear.
The electronics drawer
Done
Sold about 4 years ago !!
This will be the Type of one rank organ I will be building next.Although mine will have a set of MIDI operated chimes built in.
